NETGEAR ProSafe FVS336Gv2 Reference Manual page 351

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
9. Collect the information that you must use to configure the VPN client.
You can print the following table to keep track of this information.
Component
Pre-shared key
Remote identifier information
Local identifier information
Router's LAN network IPv4 address
Router's WAN IPv4 address
Use the NETGEAR ProSAFE VPN Client Wizard to Create a Secure Connection
to the VPN Firewall
Note: In this section, the NETGEAR ProSAFE VPN Client is referred to as
the VPN client.
The VPN client lets you set up the VPN connection manually (see
Connection to the VPN Firewall Using the NETGEAR ProSAFE VPN Client
with the integrated Configuration Wizard, which is the easier and preferred method. However,
in some situations you might prefer the manual configuration, which provides more control
over the configuration process.
The Configuration Wizard configures the default settings and provides basic interoperability
so that the VPN client can easily communicate with the VPN firewall (or a third-party VPN
device). The Configuration Wizard does not let you enter the local and remote IDs, so you
must manually enter this information.

To use the VPN Configuration Wizard to set up a VPN connection between the VPN
client and the VPN firewall:
1. On the computer that has the VPN client installed, right-click the VPN client icon in your
Windows system tray and select Configuration Panel.
Enter the information that you collected
Set Up Virtual Private Networking With IPSec Connections
349
Example
I7!KL39dFG_8
remote.com
local.com
192.168.1.0
192.168.15.175
Manually Create a Secure
on page 354) or