NETGEAR ProSafe FVS336Gv2 Reference Manual page 147

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
8. Enter the settings as described in the following table.
Setting
Route Name
Active
Private
Destination IP Address The destination IP address of the host or network to which the route leads.
Subnet Mask
Interface
Gateway IP Address
Metric
9. Click the Apply button.
Your settings are saved. The new static route is added to the Static Routes table.
Description
The route name for the static route (for purposes of identification and
management).
To make the static route effective, select the Active check box.
Note: You can add a route to the table and make the route inactive if you do not
need it. This allows you to use routes as needed without deleting and re-adding the
entries. An inactive route is not advertised if RIP is enabled.
If you want to limit access to the LAN only, select the Private check box. Doing so
prevents the static route from being advertised in RIP.
The IP subnet mask of the host or network to which the route leads. If the
destination is a single host, enter 255.255.255.255.
From the menu, select the physical or virtual network interface (the WAN1 or
WAN2 interface, a VLAN, or the DMZ interface) through which the route is
accessible.
The gateway IP address through which the destination host or network can be
reached.
The priority of the route. Select a value between 2 and 15. If multiple routes to the
same destination exist, the route with the lowest metric is used.
Configure the IPv4 LAN Settings
146