NETGEAR ProSafe FVS336Gv2 Reference Manual page 43

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
17. To configure an automatic connection reset, specify the settings as described in the
following table.
Setting Description
Select the Connection Reset check box to specify a time when the WAN connection is reset, that is, the
connection is disconnected momentarily and then reestablished. Then specify the disconnect time and
delay.
Disconnect Time Specify the hour and minutes when the connection must be disconnected.
Delay Specify the period in seconds after which the connection must be reestablished.
18. Click the Apply button.
Your settings are saved.
19. To evaluate your entries, click the Test button.
The VPN firewall attempts to make a connection according to the settings that you
entered.
20. Verify the connection:
a. Select Network Configuration > WAN Settings > WAN Setup.
The WAN Setup screen displays the IPv4 settings.
b. In the IPv4 WAN Settings table, click the Status button for the WAN interface for
which you want to display the connection status.
The Connection Status pop-up screen displays. The IP addresses that are shown in
this figure are not related to any other examples in this manual.
The Connection Status screen shows a valid IP address and gateway. You are
connected to the Internet.
Note: If the configuration was not successful, see
Connection on page 615.
Configure the IPv4 Internet and WAN Settings
43
Troubleshoot the ISP