Appendix A Default Settings And Technical Specifications; Factory Default Settings - NETGEAR ProSafe FVS318N Reference Manual

Default Settings and Technical
A.
Specifications
This appendix provides the default settings and the physical and technical specifications of the
wireless VPN firewall in the following sections:
•

Factory Default Settings

• Physical and Technical Specifications
Factory Default Settings
You can use the factory default Reset button located on the rear panel to reset all settings to
their factory defaults. This is called a hard reset (for more information, see
Default Settings
• To perform a hard reset, press and hold the factory default Reset button for
approximately 8 seconds (until the Test LED blinks rapidly). The wireless VPN firewall
returns to the factory configuration settings that are shown in the following table.
• Pressing the factory default Reset button for a shorter period of time simply causes the
wireless VPN firewall to reboot.
The following table shows the default configuration settings for the wireless VPN firewall:
Table 91. Wireless VPN firewall factory default configuration settings
Feature
Login settings
User login URL
Administrator user name (case-sensitive)
Administrator login password (case-sensitive)
Guest user name (case-sensitive)
Guest login password (case-sensitive)
WAN settings
WAN IPv4 mode
WAN IPv6 mode
on page 331):
Default Behavior
https://192.168.1.1
admin
password
guest
password
NAT
IPv4 only mode
379
A
Revert to Factory