Manage The Pptp Server; Pptp Servers Overview - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
The Edit VPN Policy screen displays. The following figure shows only the top part with
the General section of the Edit VPN Policy screen for IPv6. The Edit VPN Policy screen
for IPv4 is identical to the Edit VPN Policy screen for IPv6.
9. Select the Enable NetBIOS? check box.
10. Click the Apply button.
Your settings are saved.

Manage the PPTP Server

The following sections provide information about how to manage the PPTP server:
•

PPTP Servers Overview

• Enable and Configure the PPTP Server
• View the Active PPTP Users and Disconnect Active Users
PPTP Servers Overview
As an alternate to IPSec VPN and L2TP tunnels, you can configure a Point-to-Point Tunnel
Protocol (PPTP) server on the VPN firewall to allow users to access PPTP clients over PPTP
tunnels. A maximum of 25 simultaneous PPTP user sessions are supported. (The very first
IP address of the PPTP address pool is used for distribution to the VPN firewall.)
A PPTP user typically initiates a tunnel request; the PPTP server accommodates the tunnel
request and assigns an IP address to the user. After a PPTP tunnel is established, the user
can connect to a PPTP client that is located behind the VPN firewall.
Set Up Virtual Private Networking With IPSec Connections
417