NETGEAR ProSafe FVS336Gv2 Reference Manual page 361

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
11. Specify the settings that are described in the following table.
Setting
VPN Client address
Address Type
Remote LAN address Enter 192.168.1.0 as the remote IP address (that is, LAN network address) of the
Subnet mask
Encryption
Authentication
Mode
PFS and Group
12. Click the Save button.
Your settings are saved. Continue the manual configuration of the VPN client with the
global parameters.
13. In the tree list pane
Set Up Virtual Private Networking With IPSec Connections
Description
Either enter 0.0.0.0 as the IP address, or enter a virtual IP address that the VPN
client uses in the VPN firewall's LAN.
The computer for which the VPN client opens a tunnel appears in the LAN with this
IP address.
From the menu, select Subnet address.
This selection defines which addresses the VPN client can communicate with after
the VPN tunnel is established.
gateway that opens the VPN tunnel.
Enter 255.255.255.0 as the remote subnet mask of the gateway that opens the
VPN tunnel.
From the menu, select 3DES as the encryption algorithm.
From the menu, select SHA-1 as the authentication algorithm.
From the menu, select Tunnel as the encapsulation mode.
Select the PFS check box and from the menu, select the DH2 (1024) key group.
Note: On the VPN firewall, this key group is referred to as Diffie-Hellman Group 2
(1024 bit).
of the Configuration Panel screen,
359
click Global Parameters.