Set Limits For Ipv4 Sessions - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > Firewall > Attack Checks.
The Attack Checks screen displays the IPv4 settings.
7. In the upper right, select the IPv6 radio button.
The Attack Checks screen displays the IPv6 settings.
8. To block VPN pass-through for IPSec traffic, clear the IPsec check box, which is selected
by default to allow VPN pass-through for IPSec traffic.
9. Click the Apply button.
Your settings are saved.

Set Limits for IPv4 Sessions

You can specify the total number of sessions that are allowed, per user, over an IPv4
connection across the VPN firewall. The session limits feature is disabled by default.

To enable and configure session limits:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
Customize Firewall Protection
272