Vpn firewall 200 with 8-port 10/100 and 1 gigabit lan and dual wan port switch (2 pages)
Summary of Contents for NETGEAR ProSafe FVS338
Page 1
This application note describes how to configure a VPN policy to support a remote gateway IP set to 0.0.0.0.on one WAN interface of a NETGEAR FVX538 or FVS338 ProSafe VPN Firewall. This is an updated version using the version 2.x router firmware.
Page 2
V e r if yi n g t h e IK E a n d V PN p o l ic y 1. From the VPN menu, select Policies. 2. Select the VPN Policies tab to verify that the VPN policy is in the list. 3.
Page 3
M od i f yi n g t he R e m ot e E nd po int A dd res s 1. From the VPN menu, select the Policies submenu. 2. Select the VPN Policies tab, and click Edit for the VPN policy you created (in this example conn1)..
Page 4
Setting the Remote Endpoint Address for a Manually Created VPN Policy After you manually add an IKE and VPN policy, you can manually set the remote endpoint address. To manually set the remote endpoint address: 1. From the VPN menu, select the Policies submenu. 2.