NETGEAR ProSafe FVS336Gv2 Reference Manual page 170

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Network Configuration > LAN Settings.
The LAN Setup screen displays the IPv4 settings.
7. In the upper right, select the IPv6 radio button.
The LAN Setup screen displays the IPv6 settings.
8. Under the List of IPv6 Address Pools table, click the Add button.
The LAN IPv6 Config screen displays.
9. Enter the settings as described in the following table.
Setting
Start IPv6 Address
End IPv6 Address
Prefix Length
10. Click the Apply button.
Your settings are saved. The new IPv6 address pool is added to the List of IPv6 Address
Pools table on the LAN Setup screen for IPv6.
Change an IPv6 LAN Address Pool
The following procedure describes how to change an existing IPv6 LAN address pool.

To change an IPv6 LAN address pool:
1. On your computer, launch an Internet browser.
Description
Enter the start IP address. This address specifies the first of the contiguous
addresses in the IP address pool. Any new DHCPv6 client joining the LAN is
assigned an IP address between this address and the end IP address.
Enter the end IP address. This address specifies the last of the contiguous
addresses in the IP address pool. Any new DHCPv6 client joining the LAN is
assigned an IP address between the start IP address and this IP address.
Enter the IPv6 prefix length, for example, 10 or 64.
Configure the IPv6 LAN Settings
169