Configure The Netgear Prosafe Vpn Client For Mode Config Operation - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Configure the NETGEAR ProSAFE VPN Client for Mode Config
Operation
Note: In this section, the NETGEAR ProSAFE VPN Client is referred to as
the VPN client.
When the Mode Config feature is enabled, the following information is negotiated between
the VPN client and the VPN firewall during the authentication phase:
• Virtual IP address of the VPN client
• DNS server address (optional)
• WINS server address (optional)
The virtual IP address that is issued by the VPN firewall is displayed in the VPN Client
Address field on the VPN client's IPSec pane (see
page 408).
Note: An IP address that is allocated to a VPN client is released only after
the VPN client has gracefully disconnected or after the SA liftetime for
the connection has timed out.

To use the Configuration Wizard to set up a VPN connection between the VPN client
and the VPN firewall with a Mode Config configuration:
1. On the computer that has the VPN client installed, right-click the VPN client icon in your
Windows system tray, and select Configuration Panel.
Set Up Virtual Private Networking With IPSec Connections
Test the Mode Config Connection
402
on