NETGEAR ProSafe FVS336Gv2 Reference Manual page 385

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
Other than the nature of the IP addresses, the settings that you must enter for IPv4 and
IPv6 are identical with one exception. The IPv4 settings require a subnet mask but the
IPv6 settings require a prefix length.
Setting
General
Policy Name
Policy Type
Select Local Gateway
Remote Endpoint
Enable NetBIOS?
Enable RollOver?
Enable Auto Initiate
Set Up Virtual Private Networking With IPSec Connections
Description
A descriptive name of the VPN policy for identification and management
purposes.
Note: The name is not supplied to the remote VPN endpoint.
From the menu, select a policy type:
• Auto Policy. Some settings (the ones in the Manual Policy Parameters
section) for the VPN tunnel are generated automatically.
• Manual Policy. All settings must be specified manually, including the ones
in the Manual Policy Parameters section.
Select a WAN interface from the menu to specify the WAN interface for the local
gateway.
Select a radio button to specify how the remote endpoint is defined:
• IP Address. Enter the IP address of the remote endpoint in the
corresponding field to the right of the radio button.
• FQDN. Enter the FQDN of the remote endpoint in the corresponding field to
the right of the radio button.
Select this check box to enable NetBIOS broadcasts to travel over the VPN
tunnel. This feature is disabled by default.
For more information about NetBIOS, see
IPSec VPN on page 416.
Select this check box to allow the VPN tunnel to roll over to the other WAN
interface when the WAN mode is set to Auto-Rollover and an actual rollover
occurs. This feature is disabled by default.
Select a WAN interface from the menu.
Select this check box to enable the VPN tunnel to autoestablish itself without the
presence of any traffic.
Note: For autoinitiation, the direction and type of the IKE policy that is associated
with this VPN policy must be either Initiator or Both but cannot be Responder. For
more information, see Manually Add an IKE Policy
383
Configure NetBIOS Bridging with
on page 368.