Factory Default Settings - NETGEAR ProSAFE SRX5308 Reference Manual

Factory Default Settings

You can use the factory default Reset button on the rear panel to reset all settings to their
factory defaults. This is called a hard reset (for more information, see
Default Settings on page 349):
• To perform a hard reset, press and hold the factory default Reset button for approximately
8 seconds (until the Test LED blinks rapidly). The VPN firewall returns to the factory
configuration settings that are shown in the following table.
• Pressing the factory default Reset button for a shorter period causes the VPN firewall to
reboot.
The following table shows the default configuration settings for the VPN firewall:
Table 100. VPN firewall factory default configuration settings
Feature
Login settings
User login URL
Administrator user name (case-sensitive)
Administrator login password (case-sensitive)
Guest user name (case-sensitive)
Guest login password (case-sensitive)
WAN settings
WAN IPv4 mode (all WAN interfaces)
WAN IPv4 load balancing settings (all WAN interfaces)
WAN IPv6 mode (all WAN interfaces)
Stateless IP/ICMP Translation (SIIT)
WAN MAC address (all WAN interfaces)
WAN MTU size (all WAN interfaces)
Port speed (all WAN interfaces)
Secondary IPv4 WAN addresses
Dynamic DNS for IPv4
WAN QoS profiles for IPv4
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Default Settings and Technical Specifications
Default Behavior
https://192.168.1.1
admin
password
guest
password
NAT
Primary WAN mode
IPv4 only mode
Disabled
Use default MAC addresses of the
VPN firewall.
1500 bytes
1492 bytes for PPPoE connections
AutoSense
None
Disabled
None
405
Revert to Factory