NETGEAR ProSafe FVS336Gv2 Reference Manual page 265

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv2
IPv6 DMZ WAN Outbound Rule: Allow a Group of DMZ User to Access an FTP
Site on the Internet
If you want to allow a group of DMZ users to access a particular FTP site on the Internet
during specific hours such as working hours, you can create an outbound rule to allow such
traffic by specifying the IPv6 DMZ start and finish addresses and the IPv6 WAN address. You
can also configure the QoS profile to maximize the throughput.

To allows a group of users on the DMZ access to an FTP site on the Internet:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > Firewall > DMZ WAN Rules.
The DMZ WAN Rules screen displays the IPv4 settings.
7. In the upper right, select the IPv6 radio button.
The DMZ WAN Rules screen displays the IPv6 settings.
8. Under the Outbound Services table, click the Add button.
The Add DMZ WAN Outbound Service screen for IPv6 displays.
Customize Firewall Protection
264