Reverting To Factory Default Settings - NETGEAR STM150 - ProSecure Web And Email Threat Management Appliance Reference Manual

To restore settings from a backup file:
1. On the Backup and Restore Settings screen (see
Restore save settings from file, click Browse.
2. Locate and select the previously saved backup file.
3. When you have located the file, click the Restore button. A warning screen might appear,
and you might have to confirm that you want to restore the configuration.
The STM restarts. During the reboot process, the Backup and Restore Settings screen
remains visible. The reboot process is complete after several minutes when the Test LED on
the front panel goes off.
WARNING!
Once you start restoring settings, do not interrupt the process. Do
not try to go online, turn off the STM, shut down the computer, or
do anything else to the STM until the settings have been fully
restored.

Reverting to Factory Default Settings

To reset the STM to the original factory default settings, click the Default button next to
Revert to factory default settings on the Backup and Restore Settings screen (see
on page 68).
The STM restarts. The Backup and Restore Settings screen remains visible during the reboot
process. The reboot process is complete after several minutes when the Test LED (STM150)
or Status LED (STM300 and STM600) on the front panel goes off.
WARNING!
When you restore the factory default settings, the STM settings
are erased. All content settings and scan settings are lost. Back
up your settings if you intend on using them.
Note: After rebooting with factory default settings, the STM administrator
account password is password, the guest account password is
guest, and the LAN IP address is 192.168.1.201.
70 | Chapter 3. Performing Network and System Management
ProSecure Web/Email Security Threat Management (STM) Appliance
Figure 41 on page 68), next to
Figure 41