Enter Added Translations; Save Translations; Add Isdn-Bri; Add The Packet Bus Support - Avaya CMC1 Installation Manual

Adding or Removing Hardware
Add ISDN—BRI

Enter Added Translations

1
Type display system-parameters customer-options and press Enter.
Ensure that the
2
Administer the other required translation data using the forms listed under Distributed
Communications System (DCS) in Administration for Network Connectivity for Avaya
Communication Manager.

Save Translations

1
Type save translation and press Enter to instruct the system to copy the translation information
to the flashcard.
Add ISDN—BRI

Add the Packet Bus Support

1
If packet bus support is not already installed, see
perform the steps.

Add Circuit Packs

1
Determine port assignment of circuit packs to be added.
2
Install the appropriate circuit packs in assigned cabinet slot (as required).
EXAMPLE:

Install Cables

1
Install cables from cabinet to the MDF as required.
NOTE:
BRI requires a 12-port backplane cable terminator (breakout connector). Connect this
terminator to the 25-pair cable. This is different from the 8-port connector used for DCP.
Enter Added Translations
1
Administer the required translation data using the forms listed under 7500D voice terminals and
8500 voice terminals in Administrator's Guide for Avaya Communication Manager.
234
field is y.
DCS
3 A
Cabinet (Port Carrier
Network)
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Add Packet Bus Support on page 228 and
07 01
Slot Port
Number Number
June 2004