Test The Ip Connections - Avaya CMC1 Installation Manual

Adding or Removing Hardware
Add Integrated Announcements/TN2501AP
add data-module
Use this command to administer the data module that is associated with the TN2501AP ethernet port.
1
At the SAT, type add data-module extension/next and press RETURN.
The Data Module screen appears.
Figure 89: Data Module screen (add data-module extension)
add data-module 30006
Data Extension: 30006
Network uses 1's for Broadcast Addresses? y
2
Set the
Type
3
Set the
Port
In the example above, 1b0333 means Cabinet 1, Carrier B, Slot 3, Port 33.
NOTE:
The port number (final two digits) is always 33 for the TN2501AP circuit pack.
4
Set the
Link
5
Set the
Network uses 1's for Broadcast Address?
requirements.
6
Type a unique name in the
7
Press ENTER to save your changes.
8
If your system uses IP routing, continue with the
9
Otherwise, go to the
add ip-route
Use this command to administer IP routes to the TN2501AP circuit pack. This administration is optional.

Test the IP connections

Use the ping and status link commands to test the new IP connections that you have administered.
226
DATA MODULE
Name: VAL#2 Data Module
Type: ethernet
Port: 1b0333
Link: 5
field to ethernet.
field to correspond to the circuit pack location.
field to an unassigned or next-available link number.
field.
Name
Test the IP connections
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Page
field according to the your network
add ip-route section.
section.
1 of 1 SPE A
June 2004