Switch Administration Before Hardware Installation; Hardware Installation - Avaya CMC1 Installation Manual

Adding or Removing Hardware
Add Integrated Announcements/TN2501AP
Switch administration before hardware
installation
Before inserting the circuit pack into a carrier, an Avaya representative must administer the VAL
customer options. Before installing the hardware, check your system for the following administration:
1
At the SAT, type display system-parameters customer-options and press RETURN.
The System Parameters Customer Options screen appears.
2
Verify that the
3
Verify that
in the system.
NOTE:
Any value greater than the default (1) means that you have the Enhanced offer.
4
Scroll to page 4.
5
Verify that the
•
n for Standard offer (10 minutes storage time) and only 1 circuit pack.
•
y for Enhanced offer (1 hour storage time) and multiple circuit packs.
If any of the preceding administration is different, you must get a License File with these customer
options enabled and install it on the switch before the TN2501AP circuit pack works.

Hardware installation

!
To prevent electrostatic discharge (ESD), be sure to wear a grounding strap while handling
the circuit pack.
1
Remove connector (if any) from the back of the switch cabinet corresponding to the TN2501AP
circuit pack slot.
2
Insert the circuit pack into any port slot and close the latch securely.
At first, both the red and green LEDs are on steady, then the green LED flashes. If there are
announcements on the circuit pack, the amber LED flashes while the announcements are copied
from FLASH to RAM. After approximately 3-5 minutes, all of the top 3 LEDs go out, although
this time is longer if there are announcements already recorded on the circuit pack.
NOTE:
If the TN2501AP or TN750 circuit packs are at the system limit and you insert a VAL
circuit pack, the red LED on that circuit pack stays on, indicating that the system does not
accept it.
3
Connect the Backplane Adapter
cabinet, corresponding to the TN2501AP circuit pack slot.
4
Connect the LAN cable to the RJ-45 connector on the Backplane Adapter.
222
field is set to V11.
G3 Version
Maximum VAL Boards
VAL Full 1-Hour Capacity?
WARNING:
(Figure
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
field is set to 1 or greater, up to the maximum number allowed
field is set for the offer that was purchased:
85) to the Amphenol connector on the back of the switch
June 2004