Avaya CMC1 Installation Manual page 259

Table 62: U.S. Robotics Modem Dip Switch Settings
Dip
Switch
1
2
3
4
5
6
7
8
Connect the Monitor, Keyboard, and Mouse
NOTE:
Only make these connections if administered locally. Not necessary if administered
remotely.
You must connect these before inserting the TN802B IP Interface.
1
Attach a VGA monitor to the VGA connector of the TN802B IP Interface external cable
assembly.
2
Attach the keyboard to the KEYBOARD connector of the external cable assembly.
3
Attach the mouse to the MOUSE connector of the external cable assembly.
4
Plug the monitor into an AC power receptacle and turn it on.
Connect the Ethernet
1
Connect the network cable to the ETHERNET connector on the TN802B external cable assembly.
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
Setting Description
UP Data Terminal Ready normal
DOWN Data Terminal Ready override
UP Verbal result codes
DOWN Numeric result codes
UP Suppress result codes
DOWN Display result codes
UP Echo offline commands
DOWN No echo, offline commands
UP Auto answer on first ring or higher if specified in NVRAM
DOWN Auto answer off
UP Carrier detect normal
DOWN Carrier detect override
UP Load NVRAM defaults
DOWN Load factory defaults
UP Dumb mode
DOWN Smart mode
Adding or Removing Hardware
Add IP Solutions
259