Disable Tti (Do Not Skip This Section!); Check Tti Status; Save Translations; Save Announcements (If Necessary) - Avaya CMC1 Installation, Upgrades And Additions

Task Table
Disable TTI
NOTE:
Do this step only if the Terminal Translation Initialization (TTI) is enabled.
!
CAUTION:
If you do not disable the TTI, the translations can be corrupted.
1. Type change system-parameters features and press
2. On the second screen, set the Terminal Translation
Initialization Enable field to n to de-activate the TTI feature.

Check TTI Status

1. Type status tti and press
2. Wait until the TTI Background Task State is completed.

Save Translations

1. Type save translation and press
to the original translation flashcard, which takes about 10 minutes.
When the save translations is successful, the error code must be a zero;
otherwise, the translations are not copied. If the translations were
corrupted, the following error message displays when logging in:
!

Save Announcements (if necessary)

NOTE:
The TN750C and TN2501AP Integrated Announcement circuit packs store
announcements in nonvolatile memory; saving the announcements to a
flashcard is optional.
1. If the PPN contains a TN750/B Announcement circuit pack, type display
announcements and press
555-233-118
Enter
WARNING:
Translation corruption detected; call Avaya distributor immediately.
NOTE:
The save translation command cannot function if translations are
corrupt. Refer to ''Translation Corruption Detected'' on page A-2
clear the problem.
.
to write all translations from memory
Enter
.
Enter
Issue 5 October 2002
Enter.
to
3-15