Set Country Options
Some country options need to be set to turn off the red alarm LEDs.
1
Enter change system-parameters country options and press Enter. A screen similar to
28
displays on the terminal. The cursor is set on the
Figure 28: Typical System Parameters Country-Options Screen
change system-parameters country-options
TONE DETECTION PARAMETERS
2
The default (United States) companding mode is mu-Law. If the country uses A-Law
companding, type A-Law. Press Enter when finished.
NOTE:
Other items eventually need to be entered on this screen, but this is all that is needed to
turn the red alarm LEDs off.
3
Set the country codes as needed in the following fields. Refer to
69 for the country codes. The United States country code (1) is shown in the example above.
•
Digital Loss Plan
•
Analog Ringing Cadence
•
Analog Line Transmission
Table 9: Country Codes
Country
USA
Australia
Japan
Italy
The Netherlands
Singapore
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
SYSTEM PARAMETERS COUNTRY-OPTIONS
Companding Mode: Mu-Law
440Hz PBX-dial Tone? n
Analog Ringing Cadence: 1
Analog Line Transmission: 1
Display Character Set: Roman
Howler Tone After Busy? n
Tone Detection Mode: 6
Interdigit Pause: short
Code
Country
1
Germany
2
Czechoslovakia
3
Russia
4
Argentina
5
Greece
6
China
Installing and Cabling the Cabinets
Activate and Administer the System
field.
Companding Mode
Base Tone Generator Set: 1
440Hz Secondary-dial Tone? n
Set Layer 1 timer T1 to 30 seconds? n
Disconnect on No Answer by Call Type? n
Table 9, Country Codes,
Code
13
14
15
16
17
18
1 of 2
Figure
Page
1 of 23
on page
69