Avaya CMC1 Installation Manual page 272

Adding or Removing Hardware
Add IP Solutions
7
Under Startup Type, select Disabled and click OK to disable IP Trunk mode.
NOTE:
If IP trunk and MedPro services are both set to automatic, the TN802B defaults to IP
Trunk and MedPro features cannot be used.
8
Select MedPro and click on Startup.
NOTE:
Do not click on Start.
9
Under Startup Type, select Automatic and click OK to enable MedPro mode.
10
Click Start > Shut Down and select
or on the TN802:
Press the recessed reset button on the faceplate (see
page 260) until the LCD shows a flashing MSHUT *. When the flashing stops and the asterisk
disappears (about 2 min), reseat the circuit pack to restart the system.
or on the SAT:
a
Type busyout board UUCSS and press Enter.
b
Type reset board UUCSS and press Enter.
c
Type release board UUCSS and press Enter.
Once the system is completely initialized, the LCD reads MEDPRO *.
!
When connected remotely via pcANYWHERE, only use the pcANYWHERE Restart
Host Computer button on the toolbar to restart Windows NT.
11
Affix the new TN802B label to the circuit pack.
12
Disconnect the monitor, keyboard, and mouse.
272
WARNING:
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Restart the computer?
Figure 99, TN802B IP Interface faceplate, on
June 2004