Avaya CMC1 Installation Manual page 252

Adding or Removing Hardware
Add IP Solutions
Figure 95: TN802B IP Interface faceplate
Figure notes
1 LCD display
2 Reset button (recessed)
3 Red board status LED
NOTE:
If replacing the existing TN799 circuit pack, remove it first and replace it with the new
one.
1
Insert the TN799B circuit pack into the port slot identified earlier.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
2
Insert the TN802B IP Interface into the right most of the three slots you reserved for it (see
96) and seat it properly.
When you plug in the TN802B IP Interface Assembly, the circuit pack starts to boot and the LCD
reads PC Boot. The circuit pack reboots automatically, and after about 3 to 4 minutes the LCD
changes to IPTRK*, the default mode, or MEDPRO*.
If the TN802B is pre-administered at the factory, it reboots several times to initialize to MedPro
mode.
252
fpdfmapd KLC 030899
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
1
2
3
4
5
4 PCMCIA card slot
5 Yellow PCMCIA disk-in-use LED
Figure
June 2004