Install The License File - Avaya CMC1 Installation Manual

Upgrading R6csi/R7csi/R8csi to Avaya Communication Manager on an Avaya DEFINITY Server CSI
Task Table

Install the License File

Pre-installation
1
Type save translation and press Enter.
After the translations have been copied (about 10 minutes), the system returns an error code,
which must be a zero; otherwise, the translations are not copied.
2
Type reset system 3 and press Enter.
Wait until the system has completely reset before continuing.
3
If the system has IP endpoints registered, unplug the Ethernet cable from the TN799 (C-LAN)
circuit pack.
This disconnects (unregisters) all IP endpoints.
4
Type set time and press Enter.
Ensure that the system date and time are set correctly.
Installation (direct connection)
If you have a direct connection between the RFA and the switch:
1
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi" chapter
of the RFA Job Aid, deliver the License File.
NOTE:
This procedure sends the License File to the switch and installs it.
2
If the system has IP endpoints registered and you unplugged the Ethernet cable from the TN799
(C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
Installation (no direct connection)
If you do not have a direct connection between RFA and the switch:
1
Go to the RFA website, and, following the instructions in the "Deliver to G3r/G3si/G3csi" chapter
of the RFA Job Aid, deliver the License File to your laptop/PC.
2
Open the License Installation Tool (LIT) application at your laptop/PC.
3
Use the LIT instructions to add a switch connection profile to the tool.
4
Use the LIT instructions to install the License File on the switch.
5
If the system has IP endpoints registered, and you unplugged the Ethernet cable from the TN799
(C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
168 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004