Administration; Place Test Call - Avaya CMC1 Installation Manual

Administration

1
Enter
list configuration all
2
Record the location (board number) of the new circuit packs and verify that all other required
circuit packs (refer to
3
Enter
add DS1 xxxxx
step 2), and the DS1 circuit pack administration form appears.
4
Set the Name
5
Set the Bit Rate
6
Set the Line Coding
7
Set the Signaling Mode
8
Set the Connect
9
Set the Interface
10
Set the Country Protocol
11
Set the Protocol Version
12
Set the CRC?
13
The Idle Code default is 11111111.
14
The DCP/Analog Bearer Capability default is 3.1 kHz.
15
Set the MMI Cabling Board
TN787F/H/J/K MMI circuit pack recorded in step 2). This must be the slot for port B of the Y-
cable.
16
MMI Interface
The
17
Enter add signaling-group next
18
Change Associated Signaling : field to y
19
Change
TN2207 PRI circuit pack, for example: 1B0517).
20
The ax Number of NCA TSC : default is
M
21
The Max Number of GA TSC : default is
22
Trunk Group for NCA TSC : ____ (leave blank)
23
Trunk Group for Channel Selection :____ (leave blank)
24
Logoff the terminal and then log back on the terminal to view your changes.

Place test call

Place multimedia data-conference call to an endpoint with known video capability to test the esm
function.
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
, and a list of the installed carriers, circuit packs, and ports appears.
ESM installation) are present.
, (where
xxxxx
field to ESM DS1
:
field to 2.048
:
field to hdb3
:
field to isdn-pri
:
field to pbx
:
field to network
:
:field
field to a
:
field to y
:
:
: field
and the signaling-group form appears.
rimary D-Channel Port : field to
P
Install multimedia call handling (MMCH)
is the location of the TN2207 PRI circuit pack recorded in
to 1
field to xxxxx (where xxxxx
ESM appears.
.
xxxx 17 (where
0.
0.
Adding or Removing Hardware
is the location of the
xxxx is the address of the
299