Install The Bri Terminating Resistor - Avaya CMC1 Installation Manual

Installation, upgrades and additions for media gateways
Table of Contents

Advertisement

Figure 55: Class of Restriction form (page 1)
Can Be Service Observed? n
Can Be A Service Observer? n
Restriction Override: none
Restricted Call List? n
Unrestricted Call List?
Category For MFC ANI:
Hear System Music on Hold? y
Automatic Charge Display? n
36
On the Class of Restriction screen (page 1), in the
none and press Enter.
37
Type Save Translation and press Enter.

Install the BRI Terminating Resistor

The resistors balance the cable plant between the receiver and the transmitter on the interface. When
using the TN2198 ISDN-BRI 2-Wire U Interface circuit pack, an NT1 is required. A terminating resistor
is always required near the terminal when the BRI S-type interface circuit pack (TN556D BRI 4-Wire S-
NT Line circuit pack) is used (see #5ESS Switch Integrated Services Digital Network Customer Premises
Planning Guide, 533-700-100).
The resistor is built into the NT1 and can be 1 of 3 values, depending on the configuration and the
distance from the NT1 to the ISDN terminal. The resistor value is controlled from the NT1. A terminating
resistor adapter may be needed near the terminal and can be placed in the satellite closet or work location.
CAUTION:
Observe the following cautions when installing the terminating resistor block (440A4 or
110RA1-12):
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
CLASS OF RESTRICTION
COR Number: 10
COR Description: supervisor
FRL: 0
Time of Day Chart: 1
Priority Queuing? n
Access to MCT? y
7
Send ANI for MFE? n_
Can Be Picked Up By Directed Call Pickup? n
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
Never touch uninsulated wires or terminals unless the telephone line has been
disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Installing and Cabling the Cabinets
Install the BRI Terminating Resistor
Calling Party Restriction: none
Called Party Restriction: none
Forced Entry of Account Codes? n
Direct Agent Calling? n
Facility Access Trunk Test? n
Can Change Coverage? n
Fully Restricted Service? n
Hear VDN of Origin Annc.? n
Add/Remove Agent Skills? n
PASTE (Display PBX Data on Phone)? n
Can Use Directed Call Pickup? n
Calling Party Restriction:
Page 1 of 3
APLT? y
field, type
109

Advertisement

Table of Contents
loading

Table of Contents