Avaya CMC1 Installation Manual page 65

Follow these steps to connect to the Avaya CMC1 Media Gateway through a modem.
1
Connect the computer to the modem.
2
Connect an analog telephone line to the left most analog-line port on the modem.
3
Make sure that the modem's DIP switches are set as shown in
Switch Settings,
Table 8: U.S. Robotics Modem Dip Switch Settings
Dip
Switch Setting
1 UP
DOWN
2 UP
DOWN
3 UP
DOWN
4 UP
DOWN
5 UP
DOWN
6 UP
DOWN
7 UP
DOWN
8 UP
DOWN
4
Plug the modem into an AC power outlet.
5
Turn on the modem.
6
Set the following port settings:
Baud rate
Data bits
Parity
Stop bits
Flow control
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
on page 65.
Description
Data Terminal Ready normal
Data Terminal Ready override
Verbal result codes
Numeric result codes
Suppress result codes
Display result codes
Echo offline commands
No echo, offline commands
Auto answer on first ring or higher if specified in NVRAM
Auto answer off
Carrier detect normal
Carrier detect override
Load NVRAM defaults
Load factory defaults
Dumb mode
Smart mode
9600
8
None
1
hardware
Installing and Cabling the Cabinets
Set Up System Access
Table 8, U.S. Robotics Modem Dip
65