Install Wideband Endpoints; Nonsignaling Configuration - Avaya CMC1 Installation Manual

Adding or Removing Hardware

Install wideband endpoints

Install wideband endpoints
Wideband endpoints include video equipment or bridges/routers for LANs. Use the running list that
accompanies the system to make cable connections.

Nonsignaling configuration

A nonsignaling connection to a wideband endpoint may connect to a channel service unit (CSU). If not
using a CSU, the distance between the system and the endpoint is limited to a few hundred feet. See
Figure 105. The maximum distance depends on the type of cable and type of endpoint.
Figure 105: Typical nonsignaling wideband configuration
cydf049 RPY 123097
Figure notes
1 Wideband endpoint (wire per
manufacturer)
2 Modular cord
3 103A or modular wall jack
4 Channel service unit (CSU)
5 H600-307 cable to DTE connector on CSU
If using a CSU, the distance between connections may be up to 1300 ft. (397.2 m). The maximum
distance to the endpoint depends on the type of cable and the specifications of the endpoint.
294
1
3
2
1
3
2
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
4
POWER AUX PORT COM PORT MODEM NETWORK
DTE
5
7
9
8
6 DS1/E1 circuit pack
7 Main distribution frame (MDF)
8 Distance limit depends on cable and
endpoint type.
9 A25D 25-pair cable (male-to-male)
6
6
June 2004