Registered Music Source; Nonregistered Music Source - Avaya CMC1 Installation Manual

Adding or Removing Hardware
Install music-on-hold

Registered music source

Refer to Figure 122
1
Determine feature port assignment from Feature-Related System Parameters form.
2
Install music source according to the manufacturer's instructions.
3
Install patch cord/jumper wires at the main distribution frame.
4
Administer the switch for the new equipment.

Nonregistered music source

Refer to Figure 123
1
Determine feature port assignment from Feature-Related System Parameters Form.
2
Install the music source according to the manufacturer's instructions.
3
Connect a cable from the assigned port carrier slot to J1 on the 909A/B universal coupler (see
Install 909A/B universal coupler
a
Connect the T-lead at pin 5 and the R-lead at pin 4 of J1 on the 909A/B universal coupler
to the corresponding leads from the TN2183.
b
Connect the CT-lead at pin 5 and the CR-lead at pin 4 of J2 on the 909A/B universal
coupler to the MDF.
4
Install patch cord/jumper wires at the MDF to connect tip and ring to the information outlet at the
music source.
5
Set the Protection/Paging switch to C1.
6
Connect a modular cord from the information outlet to the music source.
7
Connect -48V to pin 5 and -48V RET to pin 2 of J3 on the 909A/B. The power source may be an
1151A, 1151A2, or other approved power supply.
8
Administer the switch for the new equipment.
324
to install a registered music source.
and Figure 124 when installing a nonregistered music source.
on page 318). A wiring block must be locally engineered.
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004