Adding or Removing Hardware
Add IP Solutions
Figure 91: TN2302AP Amphenol Adapter
Figure notes
1
Amphenol connector to backplane
connector corresponding to
TN2302AP slot
Installing the TN2302AP IP Media Processor
To install a TN2302AP IP Media Processor, you must install
•
One or more TN2302AP circuit pack(s).
•
One or more TN799DP circuit pack(s) (a TN799DP can support more than one TN2302AP).
•
An IP Media Processor adapter.
Connect the cables for TN799DP
1
Determine into which port slots you are putting the TN799DP C-LAN circuit packs.
From the rear of the cabinet:
2
Connect a 259A connector to the backplane connector corresponding to each TN799DP slot.
3
Connect one end of each DW8 cable to each 259A connector.
Connect the cables for TN2302AP
1
Determine into which port slots you are putting the TN2302AP IP Media Processor circuit packs.
From the rear of the cabinet:
2
Connect the Amphenol connector on the adapter to the backplane connector corresponding to
each TN2302AP slot.
Connect the Ethernet
1
Connect the network cable(s) to the Ethernet connector on the TN2302AP Amphenol adapter(s).
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
238
3
1
addfipm2 KLC 083000
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
2
2
To Ethernet
3
9-pin connector for maintenance
June 2004