Avaya CMC1 Installation Manual page 249

The TN802B external cable assembly is a bundle of cables with an Amphenol connector at the end of the
bundle and various PC-type connectors (VGA, Universal Serial Bus [USB], mouse, keyboard, Ethernet,
modem, and COM2) at the ends of the individual cables. See
bundle enters the Amphenol connector.
Figure 93: TN802B IP Interface External Cable Assembly
8
Figure notes
1 Amphenol connector to connector
corresponding to TN802B slot
2 To VGA monitor
3 To USB (not used)
4 To keyboard
Connect the Cables
1
Determine into which port slots you are putting the TN799B C-LAN and TN802B IP Interface
circuit packs.
NOTE:
Make sure that at least 3 adjacent slots are free for the TN802B.
From the rear of the cabinet:
2
If adding a new TN799B, connect the 259A connector to the backplane connector corresponding
to the TN799B slot.
3
If adding a new TN799B, connect one end of the DW8 cable to the 259A connector. Connect the
other end to the customer's network.
4
Connect the Amphenol connector on the external cable assembly to the backplane connector
corresponding to the TN802B slot (the highest numbered connector of the 3 slots required)
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
7 6
Adding or Removing Hardware
Figure 93. Look for the label where the
5 4
5 To mouse
6 To ethernet
7 25-pin male connector to modem
8 25-pin male connector to COM2
Add IP Solutions
1
2
3
cbdfocto AWF 122398
249