Avaya CMC1 Installation Manual page 251

Table 60: U.S. Robotics Modem Dip Switch Settings
Dip
Switch
4
5
6
7
8
Connect the Ethernet
1
Connect the network cable to the ETHERNET connector on the TN802B external cable assembly.
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Install the Circuit Packs
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799B and TN802B circuit packs are hot-swappable, so you do not need to power
down the carrier to install them.
If you need to remove the TN802B IP Interface from the carrier at a later time, shut down
Windows NT first by pressing the recessed reset button on the faceplate (see
the TN802B IP Interface until the LCD shows a flashing MSHUT *. When the flashing
stops and the asterisk disappears (about 2 min), it is safe to remove the circuit pack.
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
Setting Description
UP Echo offline commands
DOWN No echo, offline commands
UP Auto answer on first ring or higher if specified in NVRAM
DOWN Auto answer off
UP Carrier detect normal
DOWN Carrier detect override
UP Load NVRAM defaults
DOWN Load factory defaults
UP Dumb mode
DOWN Smart mode
Adding or Removing Hardware
Add IP Solutions
2 of 2
Figure 95) of
251