Avaya CMC1 Installation Manual page 263

A-Law versus Mu-Law
For systems using A-Law companding, an additional procedure is necessary.
On the SAT:
1
Busyout the trunk group associated with the IP trunk by typing busyout board UUCSS and
pressing Enter.
In the Windows interface to TN802B:
1
Click on Control Panel > Services.
2
Highlight IP Trunk Service, then click on Stop.
3
In the lower left-hand corner, right-click Start > Explore.
4
Go to the c: drive and click on its, then bin.
5
Double-click on the its.ini file to open it in Notepad.
6
Under the [MediaLib] section, go to COMPANDING=MLAW. Change MLAW to ALAW.
7
Click on File > Save to save the file.
8
Click on File > Exit to exit Notepad.
9
Click on Control Panel > Services.
10
Highlight IP Trunk Service, then click on Start.
NOTE:
Do not select Startup.
After service has started, go to the SAT:
1
Release the trunk group associated with the IP trunk by typing release board UUCSS and
pressing Enter.
Assign Server and Domain Names
The Windows NT server identifies servers using a server name plus a domain name that locates the
named server in a particular part of the network. The TN802B IP Interface is shipped with generic server
and domain names. Assign replacement names that are meaningful within your network.
1
Click on My Computer > Control Panel > Network.
2
Select the Identification tab, then click Change.
3
Type the new server name in the
4
Type the new domain name in the
5
When prompted to reboot the computer, select one of the following options:
•
No if you have not assigned IP addresses then go to
•
Yes if you have assigned IP addresses.
Assign an IP Address
1
Click on My Computer > Control Panel > Network.
2
Click the Protocols tab.
3
Select TCP/IP Protocol from the list.
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
field.
Computer Name
field and click OK > OK > Close.
Domain
Assign an IP Address
Adding or Removing Hardware
Add IP Solutions
263