Avaya CMC1 Installation Manual page 239

Install the Circuit Packs
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799DP and TN2302AP circuit packs are hot-swappable, so you do not need to
power down the carrier or cabinet to install them.
If you are replacing the existing TN799 circuit pack, remove it first and replace it with the
new TN799DP.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
1
Insert the TN799DP circuit pack into the port slot identified earlier.
2
Insert and latch the TN2302AP IP Media Processor into the port slot you reserved for it (see
Figure 92).
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The RED
LED stays on until an IP address is assigned to the circuit pack.
3
Type list configuration all and press Enter to verify that the system recognizes the TN2302AP
circuit packs.
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
Adding or Removing Hardware
Add IP Solutions
239