Avaya CMC1 Installation Manual page 260

Adding or Removing Hardware
Add IP Solutions
Install the Circuit Pack
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN802B IP Interface is hot-swappable, so you do not need to power down the carrier
to install it.
If you need to remove the TN802B IP Interface from the carrier at a later time, shut down
Windows NT first by pressing the recessed reset button on the faceplate (see
the TN802B IP Interface until the LCD shows a flashing MSHUT *. When the flashing
stops and the asterisk disappears (about 2 min), it is safe to remove the circuit pack.
Figure 99: TN802B IP Interface faceplate
Figure notes
1 LCD display
2 Reset button (recessed)
3 Red board status LED
260
fpdfmapd KLC 030899
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
1
2
3
4
5
4 PCMCIA card slot
5 Yellow PCMCIA disk-in-use LED
Figure 99) of
June 2004