Set Ciscodp Holdtime; Set Ciscodp Port - Enterasys D-Series Cli Reference Manual

set ciscodp holdtime

Parameters
seconds
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the Cisco DP timer to 120 seconds.
D2(su)->set ciscodp timer 120
set ciscodp holdtime
Use this command to set the time to live (TTL) for Cisco discovery protocol PDUs. This is the
amount of time, in seconds, neighboring devices will hold PDU transmissions from the sending
device.
Syntax
set ciscodp holdtime hold-time
Parameters
hold‐time
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set Cisco DP hold time to 180 seconds:
D2(su)->set ciscodp hold-time 180

set ciscodp port

Use this command to set the status, voice VLAN, extended trust mode, and CoS priority for
untrusted traffic for the Cisco Discovery Protocol on one or more ports.
Syntax
set ciscodp port {[status {disable | enable}] [vvid {vlan-id | none | dot1p |
untagged}] [trusted {yes | no}] [cos value]} port-string
5-10 Discovery Protocol Configuration
Specifies the number of seconds between Cisco DP PDU transmissions.
Valid values are from 5 to 254 seconds.
Specifies the time to live for Cisco DP PDUs. Valid values are from 10 to 255
seconds.