Error Code Fip - Epson AcuLaser C2900N Service Manual

Chapter 1 Troubleshooting

3. Error Code FIP

FIP-1.1 004-310: IOT Option Feeder I/F Failure
Step
Possible causative parts:
HARN ASSY OPTION (PL3.1.20)
PWBA MCU (PL8.2.13)
FEEDER ASSY OPT (PL12.1.3)
HARN ASSY TRAY (PL12.3.23)
Checking the Optional Feeder for installation.
1
Is the Optional Feeder installed correctly?
2 Does the error still occur when printing?
Checking the connectors for connection.
Check the connections between the PWBA FEED H and
3
PWBA MCU.
Are P/J27, P/J273, and P/J419 connected surely?
4 Does the error still occur when printing?
Checking the HARN ASSY TRAY for continuity.
Disconnect P/J419 from the PWBA FEED H.
5
Disconnect P/J273 from the HARN ASSY OPTION.
Is each cable of P/J419 <=> P/J273 continuous?
Checking the HARN ASSY OPTION for continuity.
Disconnect P/J27 from the PWBA MCU.
6
Disconnect P/J273 from the HARN ASSY TRAY.
Is each cable of P/J27 <=> P/J273 continuous?
Checking after replacing the FEEDER ASSY OPT.
7 Replace the FEEDER ASSY OPT. (Refer to RRP10.1.)
Does the error still occur when the power is turned ON?
Epson AcuLaser C2900N
Check
1 - 25
Remedy
Yes
Reseat the
Go to step 3. Optional Feeder,
then go to step 2.
Go to step 3. End of work.
Reconnect the
connector(s)
P/J27, P/J273
Go to step 5.
and/or P/J419
surely, then go to
step 4.
Go to step 5. End of work.
Replace the
Go to step 6. HARN ASSY
TRAY.
Replace the
Go to step 7. HARN ASSY
OPTION.
Replace the
PWBA MCU. End of work.
(Refer to RRP8.9.)
Revision B
No
Confidential