Jam Detection Timing / Action To Be Taken; Paper Feed Area Jam / Paper Transport Area Jam; Fuser Area Jam / Paper Eject Area Jam - Epson EPL-6200 Service Manual

EPSON EPL-6200/EPL-6200L

3.3.3 Jam Detection Timing / Action to be Taken

3.3.3.1 Paper Feed Area Jam / Paper Transport Area Jam

Detection Timing
Table 3-23. Paper Feed Area Jam / Paper Transport Area Jam
Category
After start of paper feeding, the Paper Feed Sensor turned ON
earlier than the passage of the predetermined time.
Jam detection in paper feed
area
The Paper Feed Sensor did not turn ON even after the passage of
the predetermined period of time from start of paper feeding.
After the Paper Feed Sensor turned ON, it turned OFF earlier than
the passage of the predetermined time.
Paper eject area
The Paper Feed Sensor did not turn OFF even after the passage of
the predetermined period of time from turning ON of the Paper
Feed Sensor.
Remaining paper detection After start of paper feeding, paper transport stopped before the
in paper feed area Paper Feed Sensor turned OFF.
The Paper Feed Sensor was ON at turning on of the Main Switch,
at opening and closing of the front door, at occurrence of a paper
Remaining paper detection
jam or at stop of paper transport.
in paper eject area
At stop of paper transport, there is paper between the Paper Feed
Sensor and the Paper Eject Sensor.
Solution: Check the "
Initial Check Items" (p.116)
following components in the order named with new ones and repeat
checking.
1. Paper Feed Solenoid
(p.157)
2. Paper Feed Roller (Lower Cassette)
3. Paper Feed Sensor (S1)
4. Eject Sensor (PS3)
5.
Main Board Assy (C533/C534 Main) (p.146)
Before replacing any electrical part, check to see if the part in
question is defective or not by consulting
Electrical Parts"
(p.121)
Troubleshooting
Explanation
first and then replace the
(p.161)
"3.5 Troubleshooting for
. Then replace the part, if necessary.
Troubleshooting for Paper Jam

3.3.3.2 Fuser Area Jam / Paper Eject Area Jam

Detection Timing
Fuser Area Jam / Paper Eject Area Jam
Table 3-24.
Category
The light to the Paper Eject Sensor was transmitted at turning on of
Remaining paper
the Main Switch, at opening and closing of the front door, at
detection in fuser area
occurrence of a paper jam or at stop of paper transport.
The light to the Paper Eject Sensor was transmitted earlier than the
passage of the predetermined period of time from the turning on of
the Paper Feed Sensor.
Paper eject area
The light to the Paper Eject Sensor was not transmitted even after
the passage of the predetermined period of time from the turning on
of the Paper Feed Sensor.
The light to the Paper Eject Sensor was intercepted earlier than the
Paper eject area jam passage of the predetermined period of time from the turning off of
the Paper Feed Sensor.
Solution: Check the "
Initial Check Items" (p.116)
following components in the order named with new ones and repeat
checking.
1. Paper Feed Sensor (S1)
2. Eject Sensor (PS3)
3.
Main Board Assy (C533/C534 Main) (p.146)
Before replacing any electrical part, check to see if the part in
question is defective or not by consulting
Electrical Parts"
(p.121)
Revision A
Explanation
first and then replace the
"3.5 Troubleshooting for
. Then replace the part, if necessary.
117