Loading Solenoid Removal - Epson DFX-8000 Service Manual

3.2.7.5 Loading Solenoid Removal

Remove the upper housing. (Refer to section 3.2.3.4.)
Step 1:
Disconnect the loading solenoid cable (black) from the terminal board. (See APPENDIX, Figure
Step 2:
A-2.)
Step 3: Remove the two CP (SP) (M3 X 6) screws securing the loading solenoid to the left frame, while
holding the solenoid
Remove the loading solenoid and iron core.
Step 4:
A S S E M B L Y P O I N T :
When connecting the cable which was disconnected in Step 2 above to the connector on the terminal
board, refer to Figure A-2 "Terminal Board Cable Connections."
CP (SP)
Figure 3-32. Loading Solenoid Removal
Left Frame
3-29
REV.-A
noid