Developer Motor Assy. Removal; Rear Rack Bearing Removal - Epson ACULASER COLOR 2000 Service Manual

EPSON AcuLaser C2000 / AcuLaser C1000

4.2.19.5 Developer Motor Assy. Removal

1. Remove the Rear Controller Cover. (See "Rear Controller Cover Removal"
on page -145.)
2. Remove the Rear Cover. (See "Rear Cover Removal" on page -146.)
3. Remove the PU1 Support Plate. (See "PU1 Support Plate Removal" on
page -154.)
4. Remove 1 Tension Spring installed on the installation plate of Developer
Motor Assy. and Transfer Motor.
5. Remove the harness from 4 harness cramps of Developer Motor
Installation Plate.
6. Remove 4 screws securing Developer Motor Assy. and 1 harness.
Figure 4-47. Developer Motor Assy. Removal
Disassembly and Assembly

4.2.19.6 Rear Rack Bearing Removal

1. Remove the Rear Controller Cover. (See "Rear Controller Cover Removal"
on page -145.)
2. Remove the Rear Cover. (See "Rear Cover Removal" on page -146.)
3. Remove the PU1 Support Plate. (See "PU1 Support Plate Removal" on
page -154.)
4. Remove Developer Motor Assy. (See "Developer Motor Assy. Removal" on
page -166.)
5. Remove 3 connectors of Rear Rack Bearing and 4 screws.
6. Slowly pull Front Bearing and remove it.
Figure 4-48. Rear Rack Bearing Removal
Disassembling Procedure
Revision E
166