Carriage Unit / Cr Guide Shaft Removal - Epson Stylus PHOTO 950 Service Manual

EPSON Stylus PHOTO 950
C A U T I O N When removing or re-installing the Printhead, do not touch the
surfaces of the nozzles against the Carriage Unit.
A D J U S T M E N T Adjustments must be carried out after the printhead has been
R E Q U I R E D
removed or replaced. The following adjustments must be carried
out in the order given.
Adjustment list 1: When the printhead has been removed
1. Platen Gap Adjustment
2. Head Angular Adjustment
3. Bi-D Adjustment
Adjustment list 2: When the printhead has been replaced
1. Platen Gap Adjustment
2. Head ID Input
3. Head Angular Adjustment
4. Bi-D Adjustment
DISASSEMBLY AND ASSEMBLY
(not replaced)

4.2.6 Carriage Unit / CR Guide Shaft Removal

1. Remove the Printer Mechanism. (Refer to Section 4.2.1.3.)
2. Remove the Printhead. (Refer to Section 4.2.5.)
A D J U S T M E N T
Adjustments must be carried out after the printhead has been
R E Q U I R E D
removed or replaced. The following adjustments must be carried
out in the order given.
Adjustment list 1: When the printhead has been removed
1. Platen Gap Adjustment
2. Head Angular Adjustment
3. Bi-D Adjustment
Adjustment list 2: When the printhead has been replaced
1. Platen Gap Adjustment
2. Head ID Input
3. Head Angular Adjustment
4. Bi-D Adjustment
3. Remove the five screws 6) C.B.S 3x6 that are securing the CR Guide Plate, and then
remove the CR Guide Plate.
2
CR Guide Plate
Figure 4-35. CR Guide Plate Removal
Disassembly
(not replaced)
6) C.B.S 3x6
4
3
5
Dowels
Revision A
1
110