Removing The T320 Control Boards; Figure 45: Removing A T320 Sib - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
See Also
Removing the T320 Control Boards
Copyright © 2018, Juniper Networks, Inc.
Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the ejector
3.
handles on each side of the SIB faceplate.
Flip the ejector handles outward to unseat the SIB.
4.
Grasp both ejector handles, pull firmly, and slide the SIB about three-quarters of the
5.
way out of the chassis.
Place one hand underneath the SIB to support it and slide it completely out of the
6.
chassis. Place it on the antistatic mat.
CAUTION:
Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Repeat the procedure for each of the remaining SIBs.
7.
Figure 45: Removing a T320 SIB
T320 Switch Interface Boards (SIBs) Description on page 85
Maintaining the T320 SIBs on page 286
Installing a T320 SIB on page 260
The router can have up to two control boards. These are located in the upper rear of the
chassis in the slots marked
To remove a control board (see
Chapter 18: Installing the T320 Without a Mechanical Lift
and
. Each one weighs approximately 5 lb (2.3 kg).
CB0
CB1
Figure 46 on page
134):
133
Advertisement
Table of Contents
Troubleshooting
