Dot1X Quiet-Period - 3Com 5500G-EI Command Reference Manual

dot1x quiet-period

Parameter
Configures the 802.1x authentication system to perform
macbased:
authentication on the supplicant based on MAC address.
Configures the 802.1x authentication system to perform
portbased:
authentication on the supplicant based on interface number.
interface interface-list
interfaces, expressed in the format
interface-num
] } & < 1-10 >
interface in the format
, where interface-type specifies the interface type,
interface-name
}
specifies the interface number and
interface-num
interface name. For the respective meanings and value ranges, see the parameters
in the Port Command chapter.
Description
Use the
dot1x port-method
perform access control on the specified interface. Use the
command to restore the default access control base.
port-method
By default, the value is
This command is used to set the base for 802.1x to perform access control,
namely authenticate the users, on the specified interface. When
the users accessing this interface must be authenticated independently, and as
such will be able to access the network as long as they independently require.
When is used, only the first user on that port needs to be
portbased
authenticated. Subsequent users accessing the network through this port are
considered authenticated. However if the original user terminates his connection,
the other users will need to be re-authenicated.
This command has an effect on the interface specified by the parameter
interface-list when executed in System View. It has an effect on all the interfaces
when no interface is specified. The parameter interface-list cannot be input when
the command is executed in Ethernet Port View and it has an effect only on the
current interface.
Related command:
display dot1x
Example
To authenticate the supplicant based on the interface number on Gigabitethernet
1/0/1, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl-Z
[SW5500]dot1x port-method portbased interface gigabitethernet 1/0/1
Command
dot1x quiet-period
undo dot1x quiet-period
Ethernet interface list including several Ethernet
:
interface-list
.
interface-num
interface-num = { interface-type interface-num
command to configure the base for 802.1x to
.
macbased
.
802.1x Configuration Commands
interface-num
= {
specifies a single Ethernet
interface-name
undo dot1x
macbased
349
[ to
|
specifies the
is used,