Mounting Or Replacing A Gearbox (Only Relevant For 300 W Motors) - Siemens SIMODRIVE POSMO A User Manual

08.01 05.13 04.01
7.2 Mounting or replacing a gearbox (only relevant for 300 W
motors)
What is required to The following materials and tools are required to mount or replace a
mount or replace gearbox:
gearboxes?
1. Four retaining screws per motor (M6 x 20 acc. to DIN 6912)
2. Tools:
3. Sealing agent:
4. Loctite:
5. Solvent:
6. New gearbox: refer to the modular gearboxes in Chapter 2.5.2
What preparations The following preparations must be made before mounting or changing
have to be made? gearboxes:
S
S
S
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition

7.2 Mounting or replacing a gearbox (only relevant for 300 W motors)

SW 4 and SW 5 Allen keys
(e.g. Fluid D from Teroson)
(e.g. Loctite Type 649)
(e.g. Seevenax 72)
This point is only valid if the gearbox is be replaced
– Remove the cover from the mounting hole
– Rotate the clamping hub with respect to the adapter plate in or-
der to line–up the mounting holes
– Release the clamping hub coupling of the gearbox
– Release the 4 screws between the motor and gearbox
– Remove the gearbox
Prepare the gearbox to be mounted
– Clean the opening for the gearbox input shaft
– Clean the mounting surface and remove any possible damage
(e.g. impressions in the mating surfaces, burs)
Preparing the motor
– Clean the motor shaft
– Clean the mounting surface and remove any possible damage
(e.g. impressions in the mating surfaces, burs)
– Apply a sealing agent to the motor flange
7 Installation and Service
7-255
7