Siemens SIMODRIVE POSMO A User Manual page 60

08.06 02.99
3. Insert the extension set "separate version" POSMO A – 300 W at
4. Using the 4 retaining screws supplied, screw the extension set to
5. Attach the potential bonding and protective conductor (cross–
Note:
Minimum bending radius of
the cables, 100 mm
3
4
Fig. 2-30 Mounting the extension set "separate version" POSMO A – 300 W
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
the motor and drive unit.
the motor and drive unit.
– Torque wrench (Allen key, SW 3)
– Tighten the screws diagonally
– Torque: 1.8 Nm
section: w 4 mm
2
)
– At the drive unit: Two screw terminals (M5) on the cover
––> refer to Chapter 2.3.1
– At the motor: Two of the three screw threads (M5) for the trans-
port lugs ––> refer to Fig. 2-30
4 screws supplied loose
with the equipment
Connector A
Extension set, "separate version"
5
Potential bonding and protective conductor (both ends) M5 x 10
2 Installing and Connecting–Up
2.4 Mounting SIMODRIVE POSMO A
3
Connector B
5
4
not to scale
2
2-59