Siemens SIMODRIVE POSMO A User Manual page 293

E Index
Programming, using SimoCom A (from SW
1.5), 3-79
Programs, 1-21, 5-140, 5-141
Classifying the, 5-141
Program areas, 5-140
Program control word (PSW), 5-144
Selecting and controlling, 5-151
Proper use, xi
Protective conductor, 2-44
Protective grounding, 2-50
Q
Qualified personnel, ix
R
References, B-267
Referencing, 5-155
Limitations for, 5-156
Overview, 5-155
Reset (from SW 1.4), 5-156
Set via actual value, 5-157
to cam with reversal, 5-161
to cam without reversal, 5-159
to occurring zero mark (from SW 2.1),
5-163
to zero mark via the traversing block
(from SW 1.4), 5-157
via fixed endstop, 5-158
Regenerative feedback protection, 2-37
Replacement parts, 7-254, 7-257
Replacing
the drive unit (300 W motor), 7-258
the gearbox (300 W motor), 7-255
the motor, 7-253
Replacing a motor, 7-253
Replacing the drive unit (only 300 W motor),
7-258
Revisions, v
Rotary axis, 3-90, 5-175
S
S1 continuous duty, 2-65, 2-68
S1 switch S1, 2-45, 2-48
S3 intermittent duty, 2-65, 2-68
E-292
Safety information/instructions, x
Screwdriver
for connection cover, 2-44
for connection module, 2-46, 7-260
for cover (measuring), 6-250
for terminals, 2-45
Sequence diagram "Variable–speed drives"
n–set mode, 4-119
pos mode, 4-118
Set actual value
Flying (from SW 1.4), 5-170
via traversing block, 5-157
Write via P40, 5-157
Settings at the DP master, 4-130
Shaft load capability
Gearbox shaft (300 W motor), 2-70
Gearbox shaft (75 W motor), 2-65
Motor shaft (300 W motor), 2-69
Motor shaft (75 W motor), 2-64
SIMATIC blocks, 3-78
SimoCom A (from SW 1.5)
Entry in, 3-83
Information on, 3-84
Installing/un–installing, 3-80
Integrated help, 3-87
Optimum version, 3-79
SIMODRIVE POSMO A
Function overview, 1-22
Product Brief, 1-19
System overview, 2-29
Wiring overview, 2-43
SITOP power, 2-33, 2-34
Software Class C, 3-78
Software limit switch, 5-195
Software release, ix
Speed controller
Integral action time, 3-92, 3-93
P gain, 3-92, 3-93
P gain, standstill (zero speed), 3-92, 3-93
Standalone mode (from SW 1.2), 5-185
Status signal
for faults (ZSW.3), 6-235
for warnings (ZSW.7), 6-236
Step–down ratio, 2-61, 2-62
Support, iv
SW limit switches-, 5-195
System overview, 2-29
System requirements, 2-30
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
08.06 10.07 06.05