Siemens SIMODRIVE POSMO A User Manual page 205

5 Description of the Functions
5.6 Parameters for SIMODRIVE POSMO A
P0003 / 03 Gearbox step-down ratio
300W
Min Standard
–200000 1
The step-down ratio should be entered in accordance with the gear used.
Note:
P3 = 0 is not permissible.
Sign change ––> direction of rotation change
This parameter has a gearbox-dependent factory default.
The following applies before SW 1.3: Min. value = 0.0001
The following applies from SW 1.6:
With a modulo axis (P1 > 0), the gear reduction ratio is limited by the path per gear revolution
and the axis type.
The following formula applies:
F = Conversion factor (mm ––> F = 1 ; inch ––> F = 25.4)
|P3| < 2147483647 * P2 / (F * 4096 * P1)
075W
Min Standard
–200000 1
The step-down ratio should be entered in accordance with the gear used.
Note:
P3 = 0 is not permissible.
Sign change ––> direction of rotation change
This parameter has a gearbox-dependent factory default.
The following applies before SW 1.3: Min. value = 0.0001
The following applies from SW 1.6:
With a modulo axis (P1 > 0), the gear reduction ratio is limited by the path per gear revolution
and the axis type.
The following formula applies:
F = Conversion factor (mm ––> F = 1 ; inch ––> F = 25.4)
|P3| < 2147483647 * P2 / (F * 816 * P1)
P0004 / 04 Dimension units
300W 075W
Min Standard
0 0
Dimension units for parameter values (0 = mm, 1 = degree, 2 = inch).
P0005 / 05 Reference point coordinate
300W 075W
Min Standard
–200000 0
The parameter specifies the position at the reference point.
Note:
The parameter value can be changed while traversing.
5-204
Max Unit
200000 –
Max Unit
200000 –
Max Unit
2 –
Max Unit
200000 MSR
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
Data type Effective
C4 immed.
Data type Effective
C4 immed.
Data type Effective
I2 immed.
Data type Effective
C4 immed.
E Siemens AG 2013 All Rights Reserved
04.01 08.06 02.99