Table of Contents
Advertisement
10.07
08.06
06.05
T
Technical data
300 W motor, 2-67
75 W motor, 2-63
Ambient conditions, 2-71
Electrical data, 2-63, 2-67
Holding brake, 300 W motor, 2-69
Motor data 300 W motor, 2-69
Motor data 75 W motor, 2-64
Technical Support, iv
Telegram structure for cyclic data transfer,
4-102
Telegram substitution (from SW 3.0), 5-197
Terminal status (from SW 1.4), 4-112, 5-183
Terminals, 2-44, 2-45, 2-47, 5-182
Terminating resistor, 2-45, 2-48, 2-49
Tool
for connection cover, 2-44
for connection module, 2-46, 7-260
for cover (measuring), 6-250
for replacing gearboxes (300 W motor),
7-255
for replacing the drive unit (300 W mo-
tor), 7-258
for terminals, 2-45
Tightening torque, 2-45
Tracking mode, 5-154
Travel to fixed stop, 5-158, 5-173
Traversing blocks, 1-21, 5-140
Classifying the, 5-140
Pre–assignment block 3 to 27, 5-142
Pre–assignment, blocks 1 and 2, 5-142
Programming the, 5-143
Selecting and controlling, 5-151
Structure of, 5-143
Traversing possibilities, 1-21, 5-144
Traversing without PROFIBUS and parame-
terization (from SW 1.4), 5-184
U
UL approval, viii, 1-27, 2-31
Unit, 5-201
Using the manual, v
V
Varistor, 1-27, 2-31
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
Version
of SimoCom A, ix
of the firmware, ix
of the hardware, ix
of the motor, ix
Overview, ix
W
Warnings, x, 6-236
Bits and numbers, 6-234
Difference to faults, 6-235
Evaluating via PROFIBUS?, 6-236
Overview, 6-234
Status signal (ZSW.7), 4-111, 4-114,
6-236
Which ones apply here?, 6-234
Water loop, 2-57
Weights
for a 300 W motor, 2-71
for a 75 W motor, 2-65
What is new?
for SW 1.2, vi
for SW 1.3, vi
for SW 1.4, vi
for SW 1.5, vi
for SW 2.0, vii
for SW 2.1, vii
for SW 3.0, vii
for SW 3.1, vii
Wiring overview, 2-43
X
X1, 2-45, 2-47
X2, 2-45, 2-47
X3, 2-45, 2-47
X4, 2-45, 2-47
X5, 2-45, 2-47
X6, 2-45, 2-48
X7, 2-45, 2-48
X9, 2-45, 2-48
Z
Zero mark, 5-156, 5-159, 5-161
Zero speed monitoring, 5-181
E Index
E
E-293
Advertisement
Table of Contents
