Siemens SIMODRIVE POSMO A User Manual page 262

10.07 04.01
How do you The connection module is replaced as follows:
replace the
connection
Caution
module?
The positioning motor must be brought into a no–voltage condition
before the connection module is replaced.
1. Release the power and signal cables (refer to Chapter 2.3.1)
2. Remove the connection cover
3. Release the four screws retaining the connection module
4. Mount the new connection module to the drive unit
5. Tighten the four screws retaining the drive unit
6. Locate the connection cover and tighten the screws
7. Connect the power and signal cables (refer to Chapter 2.3.1)
8. Test the positioning motor
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
7.3 Spare parts for SIMODRIVE POSMO A
– Tool
– Tool
– Tool
– Tightening torque
– Tool
7 Installation and Service
Screwdriver, Size 4 (1.0 x 6.5)
Screwdriver Torx T10
Screwdriver Torx T10
max. 1.8 Nm
Screwdriver, Size 4 (1,0 x 6,5)
7
J
7-261