Table of Contents
Advertisement
3 Commissioning
3.2 Commissioning the DP master
3.2.2
SIMATIC S7 function blocks
Product Brief
Which blocks are
available?
Where are these
function blocks?
Software Class C
Installation
3-78
Using these function blocks, it is simpler to control and parameterize a
SIMODRIVE POSMO A positioning motor from a SIMATIC S7 program
simplified from this.
This means that a drive, for example, can be parameterized without
being knowledgeable about PROFIBUS parameter formats and the
task IDs.
The following function blocks are available:
S
FB 10
CONTROL_POSMO_A (from 02.00)
S
FB 11
PARAMETERIZE_POSMO_A (from 02.00)
S
FB 12
PARAMETERIZE_ALL_POSMO_A (from 05.00)
You can obtain all of the function blocks up to Version 1.5 at no charge
from your local Siemens office (sales partner). However, these function
blocks do not support the "speed setpoint" mode and will not be further
innovated.
Function blocks with expanded functional scope (including the "speed
setpoint" operating mode) are available in the software package
"Drive ES SIMATIC" from Version 5.3 onwards.
Siemens AG accepts no liability and no warranty that these block ex-
amples operate error–free.
The software license conditions according to Class C apply.
––> Refer to the description of the function blocks which has also been
installed
Prerequisites: SIMATIC S7 Manager version 4.02 and higher
Run the unzipped file "setup.exe" and following the instructions.
The function blocks are then available in the SIMATIC Manager under
the "Posmo A Library Vx" library.
The associated description of the function blocks is available as pdf
document under:
Start ––> Simatic ––> S7 Manuals ––> Posmo A Library
Reader's note
In order that you always have an up–to–date description which
matches the blocks, please refer to the information on the blocks
provided in the PDF document which was also installed.
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
E Siemens AG 2013 All Rights Reserved
04.01
05.03
02.99
Advertisement
Table of Contents
