Table of Contents
Advertisement
3 Commissioning
3.1 General commissioning information
Overview of the
communications
Master
PROFIBUS–DP
standard master
S
Install GSD files
S
S7–300 with integrated
DP interface
S
S7 – 400
– SFC14 (SW)
– SFC15 (SW)
S
S7 – 312
S
CP 342–5
– FC1 (SW)
– FC2 (SW)
S
PC/PG+
– CP 5412
– CP 5511
– CP 5611
S
Any third–party
master
Fig. 3-1
Overview of the communications for SIMODRIVE POSMO A
LED after
power–on
3-74
PROFIBUS–DP
telegram data
For SIMODRIVE POSMO A the
following is valid:
S
PPO type 1 (PPO1)
PROFIBUS–DP
Cyclic data
refer to Chapter 4.2, e.g.
S
Control word (STW)
S
Status word (ZSW)
Parameterizing data
refer to Chapter 4.3, e.g.
S
Parameter number, Index
S
parameter value
PROFIBUS–DP
After SIMODRIVE POSMO A has been powered up, the LED has the
following status, if no fault/error has been detected:
S
LED flashes green
––> bus connection is not established (refer to Chapter 6.1)
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
Slave
PROFIBUS–DP
standard slave
S
Connect–up
S
Setting the address
S
When required, set the
terminating resistor
SIMODRIVE
POSMO A
E Siemens AG 2013 All Rights Reserved
02.99
Advertisement
Table of Contents
